Snow Load Calculator

m²
m
kg/m³
Fresh snow≈100, Packed≈300, Wet≈500 kg/m³
°
Construction Updated 16 Jun 2026

Snow Load Calculator is a construction estimator that helps you calculate snow load values from your input data. The formula used is: Load/m² = Depth × Density; PitchFactor = max(0, 1−(Pitch−30)/30) if Pitch>30°; Total = Load × Area × PitchFactor. Accepts imperial (feet, inches) or metric (metres, cm) units as labelled on each input.

Formula

Load/m² = Depth × Density; PitchFactor = max(0, 1−(Pitch−30)/30) if Pitch>30°; Total = Load × Area × PitchFactor

Example Calculation

Inputs
  • Roof Area: 80 m²
  • Snow Depth: 0.5 m
  • Snow Density: 300 kg/m³
  • Roof Pitch: 20 °

Suppose you enter: Roof Area = 80, Snow Depth = 0.5, Snow Density = 300, Roof Pitch = 20. The calculator applies the formula (Load/m² = Depth × Density; PitchFactor = max(0, 1−(Pitch−30)/30) if Pitch>30°; Total = Load × Area × PitchFactor) and shows all output values below. Change any input field to immediately see how the result changes.

Frequently asked questions

What is the Snow Load?
The Snow Load Calculator is a construction estimator that helps you calculate snow load values from your input data. Accepts imperial (feet, inches) or metric (metres, cm) units as labelled on each input.
When should I use this calculator?
Use this calculator whenever you need a quick, accurate result for snow load values from your input data without working through the arithmetic manually.
What units should I enter?
Accepts imperial (feet, inches) or metric (metres, cm) units as labelled on each input.
How accurate are the results?
Provides material and dimension estimates. Actual quantities depend on site conditions, waste, and cutting losses.
How do I interpret the result?
Always add a 10–15 % buffer to material estimates to account for waste, cutting errors, and variations in workmanship.
How can I verify the calculation manually?
Use the displayed formula and work through the numbers step by step. If your manual result differs slightly, check rounding and unit conversions first.
Can I use this for planning and budgeting?
Yes. Run best-case, expected, and worst-case inputs to compare outcomes and make safer planning decisions.