Water Soluble Fertilizer Calculator
Mix a liquid feed that hits an exact nutrient concentration. Enter the analysis from the fertilizer label (as N-P₂O₅-K₂O or as elemental N-P-K, plus calcium or magnesium if listed), choose the nutrient you are targeting and its concentration in ppm or mmol/L, and the calculator returns the grams or ounces of soluble fertilizer to dissolve, the ounces per 100 gallons, and the ppm and mmol/L of every other nutrient the recipe delivers. Switch to injector mode to size a concentrated stock tank for a 1:16, 1:100 or 1:200 proportioner, or check how many gallons of stock one bag will make.
- Label percentages are the guaranteed analysis by weight; ppm means mg per litre of water (the solution density is taken as 1 kg/L).
- Nutrients already present in the source water are not included; subtract them from the target if a water test shows significant Ca, Mg or nitrate.
- The injector ratio is the volume of diluted feed per volume of stock; check the real ratio regularly by calibration or by measuring EC.
- The calculator does not recommend a feeding rate for a crop – use grower guides or extension advice for that.
Formula
- ppm is mg of nutrient per litre of water. 200 ppm N from a 20% N fertilizer needs 200 ÷ 0.20 = 1,000 mg/L, i.e. 1 g of product per litre.
- Extension shortcut: oz per US gallon of stock = ppm × ratio ÷ (% × 75), and g/L = ppm × ratio ÷ (% × 10). The 75 is rounded; the exact figure, 1 oz per 100 US gal = 74.89 mg/L, is used here, so results run about 0.15% above the rounded rule.
- An injector with ratio 1:100 delivers 100 gallons of diluted feed per gallon of stock, so the stock must be 100 times stronger than the feed.
- Bag numbers give phosphorus and potassium as oxides. Elemental P = P₂O₅ ÷ 2.2913 and K = K₂O ÷ 1.2046, from IUPAC atomic weights (P 30.974, K 39.098, O 15.999).
- mmol/L converts to ppm by multiplying by the molar mass in g/mol: N 14.007, P 30.974, K 39.098, Ca 40.078, Mg 24.305.
200 ppm N in a 100-litre tank from 20-8-20
- How will you apply it?: batch
- Label type: oxide
- Nitrogen: 20 % N
- Phosphorus: 8
- Potassium: 20
- Calcium (optional): % Ca
- Magnesium (optional): % Mg
- Nutrient you are targeting: n
- Concentration unit: ppm
- Target concentration: 200
- Injector ratio 1 :: 100
- Volume to mix: 100
- Volume unit: L
- Bag weight (optional):
- Bag unit: lb
- Bulk density (optional): g/mL
200 ppm N is 200 mg/L. The fertilizer is 20% N, so the water needs 200 ÷ 0.20 = 1,000 mg/L = 1.000 g/L of product, or 13.35 oz per 100 US gallons. For 100 L that is 1 × 100 = 100.00 g (3.53 oz). The same 1 g/L supplies 1,000 × 0.08 = 80.0 ppm P₂O₅ (34.9 ppm P) and 1,000 × 0.20 = 200.0 ppm K₂O (166.0 ppm K).